UNIMO recessed pull handle with hook lock

Simple design with lock handle

Stainless steel that can maintain its beauty in any environment. Stainless steel is used as the material, strongly reflecting the most important thought since the founding of Union, "to make high-quality products for as long as possible." Because it is the finish of the material itself, the beauty will not be lost due to peeling or dirt.

[Product Details]

Size(mm): 120×34

Suitable door thickness: 36-40mm

material: Stainless Steel Hairline

Contents: 1 set (inside and outside)

[Notes]

• This product is a partition lock, not a display lock.
• For lightweight wooden doors. Be sure to reinforce the installation area to prevent the door from being crushed.
• This is a strike for router processing.
• The lock and strike front are stainless steel.
• [Precautions when using with overhead sliding doors]
  After installation is complete, it is expected that the lock and strike will be misaligned due to warping of the wooden fittings. Please make sure that the groove cutout dimensions for the lower guide type you are using are designed to leave a clearance of within 1 mm on one side.
• When installing, please read the attached installation instructions carefully.
  Please read the instruction manual for each product carefully for handling instructions.
  Loose mounting screws can cause rattling or the risk of injury to your hands, so be sure to tighten them all the way. Also, regularly check that the mounting screws are not loose.
  If it is loose, be sure to tighten it again.
  Using the product with loose screws may cause accidents, damage, or injury.
  Please keep the installation instructions and instruction manual so that you can refer to them at any time.
• Please do not use each product for any purpose other than its intended use.
  Unintended injuries may occur.
• To clean, wipe with a soft cloth using water or dry cloth.
  If the stain is difficult to remove, wipe it off with a diluted neutral detergent solution, then wipe with water to remove any remaining detergent, and then wipe dry.
  Please refrain from scrubbing the surface too hard with a dry cloth as this may cause scratches.
  Never use alcohol, paint thinners, carbolic acid, paint thinners, or highly concentrated acids (I.PA).
  This may cause cracks or breakage and may injure your hands.
  Please also read the care instructions for each material.
  If you already notice any cracks on the surface of the product, discontinue use immediately.
• Do not apply masking tape directly to the product, as the adhesive components may cause discoloration or peeling.
• Do not use in high temperature and humidity environments.
  There is a risk of deformation or deterioration.